How To Create A Custom Wood Accent Wall

| | |

 

Create a Custom Wood Accent wall with using common plywood installed in an uncommon manner. The project proves that high style doesn’t mean high price.

How’s life your way? Busy as usual here. Today I wanted to share with you a super easy project that will add a whole lot of bang for the buck! This custom wood accent wall tutorial can be done in a couple of days. All the materials can be found at the local hardware store and tile store.

pinterstwoodaccentwalldiyaspiringhome

In the Fall One Room Challenge, I decided to take on two powder rooms. These rooms had very different color palettes and vibes. I love them both!  I have tons of favorite projects to share over the next few weeks but this one is on the top of the list.

When putting the design together for the upstairs bathroom I so desperately wanted a burled wood-paneled wall. I thought about it, researched product all the time. I finally came to the conclusion that I could not swing the coinage needed for such a wall. The idea… well I couldn’t shake it. So I did what most DIYers do… I came up with an alternative plan!

A stroll down the aisle at Home Depot yielded ideas and I settled on thin stainable plywood. With the help of a very patient associate – we found a piece with great wood grain.  At $15 for the whole panel plus initial cuts…SOLD!

The wall behind the toilet seemed like an obvious place for the accent wall, I had envisioned beautiful Carrera stone shelves gracing that area. Didn’t get the shelves either due to budget restraints BUT I came up with an alternative and you will see the details here on the blog soon.

We measured the area which happened to be a bit taller than our wood panel. No problem- we will just fill in the blanks.

Let’s start with a really good before shot, shall we?

beforediywoodpanelaspiringhome

The wood accent wall will make such a big difference here.  I put two even coats of Minwax Special Walnut stain on the panel. Once it dried I added two coats of satin non-yellowing poly.

woodpaneldiyaspiringhome
woodpaneldiyaspiringhome2

After making sure the piece thoroughly dried, we hauled it upstairs and kinda sorta slid it into place. Thankfully the plywood was strong enough to bend and wiggle into its new home. Watch your fingers though! Hubby pinched the snot out of his.

diywoodpanelaspiringhome3
diywoodpanelaspiringhome4

I measured the bottom area of the wall while the hubs held the piece in place. Since our walls are 10ft  and the panel is 8 ft., we had to add a bit to the bottom.

We tried attaching the board to the wall using a brad nailer… didn’t work. The brad nailer shot right through the panel and into the wall. Our sheet of plywood was just to thin.  We ended up nailing by hand little brads into the edges. Once the shelves are installed- the panel will be super secure.

This project only took a few days to complete due to allowing the stain and poly to dry. The outcome is a bit Rat Pack meets the Brady Brunch and I so dig it.

One day I will have a burled custom wood accent wall… somewhere, mark my words. 😉 In the meantime, check out this chevron accent wall idea that I did for the foyer.

Let’s have a look at the after…

upstairspowderroomafter4

So stinking good-looking

‘Til Later,

SaveSave

Similar Posts

One Comment

Comments are closed.